HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 92)

Configuration

Configuring the High Availability Feature for X.25 over LLC2

Chapter 392

NOTE Enabling or disabling of HA feature for XOL interface is system wide.

Before enabling or disabling the HA feature on a system, all existing

XOL interfaces must be stopped. The XOL HA feature is enabled by default on 11i v3.

Step

1. To configure the standby device and the unique MAC address in the

nfiguration file of the XOL primary interface, modify the following

syntax:

Standby_device <standby LAN card name> # used for local

failover

XOL_floating_macaddr <unique MAC address>

NOTE Local failover is automatically enabled if a “standby_device” is defined in

the configuration file. If you do not want the local failover feature for this

interface, you must de-configure the standby_device by removing or

commenting the line in the configuration file. The XOL interface inherits

the configuration of the primary XOL interface during failover because

the same configuration file is used to configure the XOL interface.

Example 3-7 Configuring Standby Device and Unique MAC Address

If the assumptions in the XOL configuration file are the following:

• The primary LAN card is lan0

• The standby LAN card is lan1

• The MAC address is 0x0060B0A4EbE5

Then, the above parameters take the following values:

standby_device lan1

XOL_floating_macaddr 0x0060B0A4EBE5

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 92