HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 158)

PAD Ser vices

Local PAD Emulation (padem)

Chapter 6158

name Optional. This is the name of the programmatic

interface used for call setup. If this entry does not exist,

the default name associated with /dev/x25_0 is used.

This name must match the programmatic access name

(also called name) in the X.25 configuration file.

logging Optional. Specifies the logging level that applies to all

calls made during this session. The log file is

$HOME/plog.aXXXXX, where the last five characters are

from the process ID of padem. If this parameter is not

specified, the logging level is set to the default level of 0

(no logging). Logging levels are: 1 = error logging, 2 =

error and warning logging, 3 = error, warning,

information, and status logging.

reverse_charge Optional. Specifies the reverse charge option for call

setup. Possible settings are: disabled (or disable)

and enabled (or enable). The default value is

disabled. When reverse charge is enabled, padem

sends a reverse charge request with all call request

packets.

profile Optional. Describes the X.3 configuration for the login

session. The X.3 default values are defined in the code

(programmatically) and cannot be altered by users.

These default parameters comply with the 1984 profile

0 specification for a PAD device. If profile X is in

x29hosts and profile Y=X is in x3config, padem uses

profile X. If there is no profile in x29hosts, and

x3config contains profile 0, padem uses profile 0. In all

other cases padem uses the hard-coded default values.

padem only operates in line mode for X.3 configuration.

host_table{} Optional. Defines symbolic host names for remote

X.121 addresses. The first entry defines the symbolic

name and the second entry is the remote X.121

address. If an X.121 address is given, it must also exist

in the remote_x121 field in the pad_em section of the

x29hosts file.

NOTE You do NOT need to have pad_em {} entries in the

x29hosts file. You can specify all of the above

parameters at the command line when you run padem.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 158