HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 150)

PAD Ser vices

UUCP Support (x29uucpd)

Chapter 6150

x3 Optional. This is the X.3 configuration set name for

UUCP file transfers. If this entry is used in

/etc/x25/x29hosts, the configuration set name with

its set of X.3 parameters must be specified in

/etc/x25/x3config. All legal X.3 parameters

contained in the x3config file are downloaded at

connection time. If there is more than one X.3

configuration set with the same set name in

/etc/x25/x3config, the first one is used.

If there is no configuration set name in x29hosts or

matching X.3 configuration set name in x3config, the

default parameters are downloaded (see “X.3

Parameter Descriptions” for information on X.3

parameters). x29uucpd operates in line mode only.

Configuring System and Device Files for UUCP

The following example describes the configuration procedure for cu, uucp

and uucico transfers between two systems. In this example, the local

system is called “dave” and the remote system is called “bill.” The two

systems are configured to handle file transfers originating from the local

system (dave) and received by the remote system (bill).

NOTE Refer to the man pages for information on x25uucp device entry

parameters.

At the “dave” system:

Step 1. Make sure that the directory /var/spool/uucp/LCK..x29 exists. If it

doesn’t exist, create it.

Step 2. Configure the usr/lib/uucp/Systems file as follows:

bill Any;5 dev_bill, f 19200 - ““ \r\d\r\d\r login: -BREAK

-login: uucp word: test

where:

bill – is the name of the destination system (7 characters maximum).

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 150