HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 204)

Troubleshooting

Troubleshooting Your X.25 Link

Chapter 8204

Flowchart 4 – Procedures and Notes

This flowchart describes how to run a loopback test using x25check on

the local node. This checks that your X.25 link to the network or X.25

switch is working correctly.

Note 4-1 – x25check

You do a loopback test using the x25server and x25check commands.

The x25server process is only used to accept and echo back an X.25

packet coming from an x25check process. To run the loopback test, you

need:

• 2 virtual circuits (either 1 one-way inbound and 1 one-way outbound,

or 2 two-way),

• if you are connected to a private X.25 switch (rather than connected

directly to a network), then the switch must be configured to return a

call packet.

Note 4-2 – Exit

Your local X.25 configuration is correct. You can use x25check to verify

connections to the remote host only if the remote host is running and:

• has X.25 initialized,

•is running x25server,

• has an X.25 configuration that is compatible with the local host’s

configuration.

If you still experience problems, contact the System Administrator at the

remote host and ask them to check their X.25 configuration.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 204