HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 217)

Troubleshooting

Configuration and Troubleshooting Commands

Chapter 8 217

Because pvc describes a permanent circuit for a

particular interface, that interface must have been

initialized prior to the initialization of the address map

table. If the interface or the specified PVC does not

exist, an error is reported.

prog_access

_name Specifies the card's programmatic access name.

NOTE For Series 712 workstations this is always

name=interface0.

+URC Specifies that outbound calls to this IP address will

Use Reverse Charging (URC).

-URC (Default) Specifies that outbound calls to this IP

address will not Use Reverse Charging (URC).)

+ARC Specifies that inbound calls to this IP address will

Accept Reverse Charging (ARC).

-ARC (Default) Specifies that inbound calls to this IP address

will not Accept Reverse Charging (ARC).

x25_card_device A device configured for one of your existing X.25

cards. This information is used by the IP_to_X25

software to identify the interface port through which

the outbound packets will be sent.

CUG=n Specifies the Closed User Group index number used for

placing calls to this IP address. The index number is a

two- or four-digit number. Two digits corresponds to

the basic format, and four digits corresponds to the

extended format of the CUG selection facility.

# You can put comments in your IP mapping table by

including the # character at the beginning of the line.

Note that you cannot add comments after a table entry.

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 217