HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 33)

Configuration

Configuring the X.25 Link

Chapter 3 33

Network types

You must select a Network Carrier Type that matches the type of

network to which you are connected.

Table 3-1 Field Descriptions

Configuration

File name

Name of the file that will contain the parameters

for configuring the interface (a physical port). If

you are configuring more than one interface,

specify a unique configuration file for each

interface.

The configuration file must be named

x25config_npx, where n represents the

communications card number (use 0 for the first

card, increasing the value by 1 for each additional

card up to 255), p is a place marker, and x is the

port number (1 to 4). Note that p and x are only

required for systems with dual-port or quad-port

cards.

X.25 Address Address assigned to each local X.25 interface

(card or port) by the network carrier. X.25 checks

it for diagnostic and identification purposes only.

This address is sometimes referred to as the

X.121 address. Use the value given on your

subscription form.

Programmatic

Access Name

Name given to the interface you are configuring

(used for X.25 level 3 programmatic access).

Network Carrier

Type

Type of network to which the X.25 interface is

attached (as it appears on your subscription

form). A complete list of possible networks is

shown below. The default is DTE_84.

X.25 Packet

Address

This field appears (with its default value) only if

you select TRANSPAC as the Network Carrier

Type.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 260 261

Kommentare zu diesen Handbüchern

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung HP CommonIO Products