HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 48)

Configuration

Configuring Remote System Access

Chapter 348

Configuring Remote System Access

Follow the steps below to configure access to other hosts and systems

that use TCP/IP protocol. (The procedures in this section are optional.

Your X.25 link software does not require that you configure access to

other systems).

NOTE System Administration Manager (SAM) is deprecated in the 11iv3

release of HP-UX. HP System Management Homepage (HP SMH), an

enhanced version of SAM, is introduced for managing HP-UX.

Step 1. If you have not already done so, type smh at the HP-UX prompt.

Step 2. At the SMH main window, select “Tools”. Numerous object lists are

displayed.

Step 3. At the “Networking and Communications” window, highlight Hosts and

click on OPEN. Highlight Local Hosts and click on OPEN.

SMH displays all remote system names and IP addresses that have

already been configured.

Step 4. Select Add from the Actions menu. The following dialog appears:

NOTE The appearance of the “Add Internet Connectivity” dialog may be slightly

different from the example below depending on the version of the X.25

software you are running.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 48