HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 52)

Configuration

Configuring Remote System Access

Chapter 352

Table 3-13 Provide X.25 Information Field Descriptions

X25 Address X.25 address (sometimes referred to as the X.121

address) of the remote system. The X.25 address

assigned by the network provider uniquely

identifies the node in an X.25 network. The

address consists of a maximum of 15 digits. You

must complete this field.

Switched VC Enable this field if a switched virtual circuit

(SVC) will be used for this connection. When

Switched VC is enabled (default), three additional

fields can be configured: Request reverse

charging, Accept reverse charging, and Closed

user group (refer to the field descriptions below).

Permanent VC Enable this field if a permanent virtual circuit

(PVC) will be used for this connection. When

Permanent VC is enabled, two additional fields

can be configured: PVC Number and Local

Programmatic Access Name.

Request reverse

charging

Enable this field if the local system will make

collect calls to the remote system. If this field is

disabled, no collect calls can be made.

Accept reverse

charging

Enable this field if you want the local system to

accept collect calls from the remote system. If this

field is disabled, no collect calls will be accepted.

Closed user group Enable this field if you subscribed to a closed user

group (CUG) and you want to use the CUG with

this connection. Do not select this item if you did

not subscribe to a CUG or if you do not want this

connection to belong to a CUG. If you enable this

field, an additional field (CUG Number) appears.

Enter the number of the CUG to be associated

with this connection.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 52