HP CommonIO Products Bedienungsanleitung PDF herunterladen (Seite 39)

Configuration

Configuring the X.25 Link

Chapter 3 39

Enter or modify field values as required (refer to the field descriptions

below).

Step 5. Click on OK to return to the “Configure X.25 Card” window when you

have finished configuring the Internet address.

Verifying Level 3 Values

If you subscribe to a public network, the network provider will supply the

appropriate settings for most level 3 parameters. These settings will

differ depending on the network provider and the type of service to which

you subscribe. Refer to your Network Subscription Form for the correct

values for your configuration.

Follow the steps below to verify level 3 values:

Step 1. At the “Configure X.25 Card” window, select Verify Level 3 Values.

The following dialog appears:

Table 3-5 Modify IP over X.25 Defaults Field Descriptions

Idle Timer Sets the number of seconds a circuit stands idle

before it is cleared by IP. The range is 0 to 32767.

The default is 600.

Hold Timer Sets the number of seconds a circuit may be

inactive before it is designated as inactive.

Inactive circuits may be cleared when all other

circuits are unavailable and a connection request

is received by IP. Do not set the hold timer to a

value greater than the idle timer. The range is 0 to

32767. The default is 300.

MTU Size The maximum transmission unit size in octets

(bytes). The range is 20 to 8192. The default is

2048. For DDN configured interfaces, it must be

less than or equal to 1007.

System Max. IP

Connections

The maximum number of IP connections that can

be simultaneously active for the whole system.

This is a global parameter. The default value for

this parameter is 256 connections.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 260 261

Keine Kommentare

HP CommonIO Products Bedienungsanleitung Seite 39