HP 10TB Betriebsanweisung PDF herunterladen (Seite 39)

Table 3 Front LED status (continued)

StatusDescriptionItem

Flashing amber (1 Hz) = The drive is not selected and is indicating a

predictive failure.

Drive locate mode (UID LED is

flashing)

Flashing amber/green = The drive has been selected by a management

application and is indicating a predictive failure.

Amber = The drive might or might not be selected and is indicating drive

failure, link failure, or mismatched configuration.

OFF = The drive is not selected.

Flashing amber if there is a failed component in the system.

NOTE: The amber chassis fault LED flashes if any component fault is

detected by the System Management Homepage. A fault can be as minor

as a cable unplugged from a NIC port, and therefore may not be cause

for concern.

Chassis fault LED2

OFF if the system is in good health.

Solid green if the system is in good health.Chassis health LED3

OFF if there is a failed component in the system.

This is either blue or off. When on it can be steady or blinking. Used only

for unit identification. To set the LED, use the following CLI command: SET

ENCLOSURE UID { ON | OFF | SLOW | FAST }

Chassis UID LED4

OFF = Enclosure is functioning normally.

NOTE: All these LEDs are off if the enclosure has power but is turned off (see Table 11 (page 43)).

Then only the equivalent Chassis LEDs (2,3,4) on the rear Power Pod show status.

Figure 27 Hard drive LEDs

1. Fault/UID LED (amber/blue)

2. Online LED (green)

Table 4 SAS hard drive LED combinations

StatusDescriptionItem

OFF = Override drive activity output. Drive is not a member of any RAID

volumes <or> Drive is configured but in a replacement or failed state for

Activity/Online LED1

at least one volume that is a member of a RAID volume <or> Drive is a

spare drive that is or has been activated but has not been

rebuilt.<and>Drive is not rebuilding<and>Drive is not a member of a

volume undergoing capacity expansion or RAID migration.

Solid green = Drive is a member of a RAID volume <and> Drive is not a

spare drive <and> Drive is not in a replacement or failed state for any

volume that is a member of a RAID volume <and> Drive is not currently

performing I/O activity.

Blinking green (@ 4 Hz 50% of duty cycle) = Drive is currently performing

I/O activity <and> Drive is a member of a RAID volume <and> Drive is

Component LEDs 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 180 181

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 10TB Betriebsanweisung Seite 39

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP 10TB