HP 10TB Betriebsanweisung PDF herunterladen (Seite 25)

IMPORTANT: Use only one node to complete the setup procedure.

In the Set Up Windows wizard, you are asked to choose a language, regional settings, and

keyboard layout. After you accept the EULA, the server you are connected to attempts to discover

the second server. This is done over the internal switch (5, Figure 12 (page 18)). If the second

node is not ready, you may see a message stating Cannot establish communication with

the second node. Click Retry to attempt discovery, and repeat the retry until the second node

is discovered. After the second node is discovered, there will be a few more installation steps that

occur automatically on each server, and then both servers will reboot.

NOTE: If you click Cancel instead of Retry, you must access the second node from iLO or a direct

(SUV) connection and manually perform the Set Up Windows wizard on the second node. Because

the discovery process has not completed, there will also be an extra step later to establish a

connection between the two nodes. You will find instructions for this, if needed, in the online help

of the Initial Configuration Tasks (ICT).

Completing initial configuration

After the servers reboot, continue the configuration using the first node. A default administrator

password (HPinvent!) has been set and this is used to log on automatically.

NOTE: Leave this administrator password unchanged until you are prompted for a new password

in a later configuration step.

IMPORTANT: HP strongly recommends that you validate your configuration when using clusters.

Whether you create a cluster through the ICT or the Failover Cluster Manager, one of the first steps

is validating your configuration using the Microsoft cluster validation tool. If you choose to skip

the validation step, you can still validate the cluster after it is created.

After logon, the HP ICT window is launched automatically.

Use the HP ICT to perform setup tasks in the order they appear. See the provided online help for

each group of tasks for more information about the task. After completing the “Provide cluster name

and domain” task, both nodes will reboot. After allowing time for a reboot, log on once again to

the first node. This time, rather than logging on as local Administrator, log on using the domain

account that was specified in the “Provide cluster name and domain” task. You may now complete

the remaining tasks, which includes creation of the two-node cluster. You may also wait and create

file servers later using Microsoft Failover Cluster Manager, which can be launched from Server

Manager→Tools.

NOTE: If you change the network settings on the second node, it is possible that you will be

changing the network connection used to communicate with the second node. Refer to “Known

issues” (page 46) for more information.

The ICT is intended for initial setup, so once it is complete, you may select the Do not show this

window at the next logon box. If you want to launch the ICT at a later time, you may do so from

the HP StoreEasy folder on the desktop. When the ICT window closes, Windows Server Manager

opens automatically. Use Windows Server Manager to further customize the storage system, such as

adding roles and features and configuring share and storage management.

After completing the initial configuration, you can provision and manage your storage. For more

information about provisioning storage, see the HP StoreEasy 5000 Storage Online Help. To

access the online help, open the ICT from the task bar on the desktop, or from the HP StoreEasy

folder on the desktop.

Completing initial configuration 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 180 181

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 10TB Betriebsanweisung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP 10TB