HP 10TB Betriebsanweisung PDF herunterladen (Seite 117)

8. Lift the release tab on the side or bottom rail (1, Figure 104 (page 117)), and then slide the

rail toward the front of the drive drawer to remove the rail (2).

NOTE: Repeat this step for all rails.

Figure 104 Removing the drive drawer rails

Replacing the drive drawer rails

1. Align the replacement rail with the tabs, and slide it toward the back of the drive drawer until

the rail locks into place (Figure 105 (page 117)).

Figure 105 Installing the drive drawer rails

2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive

drawer partially back into the system enclosure so that approximately two inches of the drawer

is still out of the enclosure (Figure 106 (page 118)).

CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect

the power coil assembly to prevent damaging the power coil assembly.

Removing and replacing the drive drawer rails (side or bottom) 117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 180 181

Keine Kommentare

HP 10TB Betriebsanweisung Seite 117