
HP Designjet T Series — Service Manual 6-204
Removal and Installation - Electronics Module Main PCA and PSU (T1100/T1100ps/T610)
8. Remove one T-15 screw that secures the
Electronics Module to the printer.
9. Carefully lift the Electronics Module out of
the printer.
When you install the
Electronics Module make sure
it is correctly aligned with the
mounting rail.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
Kommentare zu diesen Handbüchern