
6-58 HP Designjet T Series — Service Manual
Removal and Installation
14. Carefully slide the Ink Supply Tubes
Support Rail to the left until the right end is
clear of the right Top Cover Support.
15. Remove the Ink Supply Tubes Support Rail
from the printer.
When you reinstall the Ink Supply
Tubes Support Rail make sure
that the attachment lug is
correctly engaged with the right
Top Cover Support.
When you reinstall the Ink Supply
Tubes Support Rail make sure all
the attachment brackets and
bonding leads are correctly
connected. These are important to
avoid electrostatic interference
being generated.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
Kommentare zu diesen Handbüchern