HP 2000CP 2500CP Bedienungsanleitung PDF herunterladen (Seite 273)

8-52 Removal and Installation

HP DesignJet CP Series Printers

Elevator Assembly

Refer to figure 18  page 8-54

Removal



Switch off the printer and remove the power cord.

1. Remove the ink delivery system (Refer to the User Guide).

2. Remove the following:

1. Window and Top Cover  page 8-15.

2. Left Hand Cover  page 8-18.

Note: To gain access to the screws securing the elevator

assembly to the left hand side chassis, it may be necessary to

manually raise the elevator assembly. This can be done by

turning the motor gear under the elevator assembly.

3. Remove the T-20 screw (item 1) located at the bottom rear of the elevator

assembly.

4. Loosen the three T-20 screws (item 2) securing the elevator assembly to

the left hand side chassis.

5. Remove the top half of the elevator assembly (item 3) by releasing it

from two retaining clips at the back, then lifting up and to the left.

6. Disconnect the platform sensor cable from position J5 PLATEF

SENSOR on the refill interconnect PCA and release from the cable

clamp.

7. Disconnect the elevator stepper motor cable from position J9 ELEV

STEPPER on the refill interconnect PCA and release from the cable

clamp.

8. Remove the elevator assembly by sliding it up and pulling it towards

you.

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 347 348

Keine Kommentare

HP 2000CP 2500CP Bedienungsanleitung Seite 273