HP 2000CP 2500CP Bedienungsanleitung PDF herunterladen (Seite 245)

8-24 Removal and Installation

HP DesignJet CP Series Printers

Front Panel and Stand-by Button

Refer to figure 7  page 8-25

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Window and Top Cover  page 8-15.

2. Right Hand Cover  page 8-21.

2. Remove the stand-by button cable and the front panel cable from the

wire clamps (item 1) on the inside of the right hand cover.

3. Remove the front panel (item 2) from inside the right hand cover (item 3)

by releasing it from the retaining clips.

4. Open the door (item 4) on the right hand cover.

5. Remove the stand-by button (item 5) by releasing it from the securing

clips located inside the right hand cover.

6. Remove the stand-by button through the front of the right hand cover.

Installation

1. Open the door (item 4) on the right hand cover. Feed the cable for the

stand-by button (item 5) through a hole in the front of the right hand

cover (item 3).

2. Secure the button in the cover by pushing it onto retaining clips.

3. Push the front panel (item 2) into the securing clips inside the right

hand cover.

4. Route the stand-by button cable and the front panel cable through cable

clamps (item 1) on the inside of the right hand cover.

5. Install the following:

1. Right Hand Cover  page 8-21.

2. Window and Top Cover  page 8-15.

6. Connect the power cord and turn the printer on in service mode.

7. Perform D07 Front Panel Service Test  page 4-19

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 347 348

Keine Kommentare

HP 2000CP 2500CP Bedienungsanleitung Seite 245