HP LaserJet 4300 Series Betriebsanweisung Seite 113
- Seite / 218
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
ENWW Understanding printer messages 111
22 PARALLEL I/O
BUFFER OVERFLOW
For help press
alternates with
To continue press
Too much data was sent to the parallel port.
1. Check for a loose cable connection and be sure to use a high-quality cable. (See “Ordering
information” on page 17.) Some non-HP parallel cables might be missing pin connections or
might otherwise not conform to the IEEE-1284 specification.
2. This error can occur if the driver you are using is not IEEE-1284 compliant. For best results,
use an HP driver that came with the printer. (See “Printer drivers” on page 29.)
3. Press S
ELECT ( ) to clear the error message. (The job will not be printed.)
40 EIO [X] BAD
TRANSMISSION
To continue press
The connection has been broken between the printer and the EIO card in the specified slot [X].
(Data loss might occur in this situation.)
Press SELECT ( ) to clear the error message and continue printing.
41.X PRINTER ERROR
For help press
alternates with
To continue press
A temporary printing error occurred.
1. Press S
ELECT ( ). The page containing the error automatically reprints if jam recovery is
enabled.
2. If the error does not clear, turn the printer power off, and then turn the printer power on.
41.3 UNEXPECTED
SIZE IN TRAY [XX]
For help press
alternates with
LOAD TRAY [XX]:
[TYPE] [SIZE]
For help press
The printer detected a paper size different than what it was expecting. This is typically caused if
two or more sheets stick together in the printer or if the tray is not properly adjusted.
1. Reload the tray with the correct paper size.
2. If you are printing from tray 1, verify that the correct paper size is selected at the printer
control panel. (See “Paper Handling menu” on page 154.)
3. If you are printing from any tray except tray 1, verify that the three paper size adjustments
on the tray have been made correctly. See the description of adjustments in “Loading tray 2
or an optional 500-sheet tray” on page 43 and “Loading an optional 1,500-sheet tray” on
page 45.
4. After performing the actions above, press S
ELECT ( ). The page containing the error will
automatically be reprinted if jam recovery is enabled. (Or, you might want to press C
ANCEL
JOB to clear the job from the printer memory.)
49.XXXX PRINTER ERROR
To continue turn off then
on
A critical firmware error has occurred.
1. Press S
ELECT ( ). The page containing the error automatically reprints if jam recovery is
enabled.
2. If the error does not clear, turn the printer power off, then turn the printer power on.
50.X FUSER ERROR
For help press
A fuser error has occurred.
1. Turn the printer power off, and then turn the printer power on.
2. If the message persists, contact HP Customer Support. (See “Getting support” on
page 144.)
50.5 FUSER ERROR
For help press
The printer detected that the wrong fuser is installed.
1. If this error occurred immediately after installing a maintenance kit, verify that the correct kit
was installed. (See “Part numbers” on page 18.)
2. If the message persists, contact HP Customer Support. (See “Getting support” on
page 144.)
51.XX or 52.XX PRINTER ERROR
For help press
alternates with
To continue turn off then
on
A temporary printing error occurred.
1. Turn the printer power off, and then turn the printer power on.
2. If the message persists, contact HP Customer Support. (See “Getting support” on
page 144.)
Message Explanation or recommended action
- LaserJet 4200 1
- LaserJet 4300 1
- Contents 5
- 4 Problem solving 6
- 5 Service and support 7
- Appendix C Printer commands 8
- Appendix D Specifications 8
- About the documentation 9
- Using the printer 10
- Printer basics 11
- Printer features and benefits 12
- Printer configurations 14
- Printer parts and locations 15
- Front view, tray 1 closed 16
- Rear view 16
- Accessories and supplies 17
- Moving the printer 18
- Ordering information 19
- Part numbers 20
- Cables and interfaces 21
- Documentation 22
- Maintenance 22
- Printing supplies 23
- Control panel layout 26
- Control panel buttons 27
- Printer software 30
- Printer drivers 31
- Network administrators 32
- Printer driver Help 33
- HP LaserJet Utility 34
- Software for networks 35
- Printing tasks 37
- Selecting the output bin 38
- Stapling documents 41
- Loading staples 43
- Loading trays 44
- Understanding tray order 48
- Customizing tray 1 operation 49
- Printing envelopes 53
- Loading envelopes in tray 1 54
- Printing special paper 59
- Printing labels 60
- Printing transparencies 61
- (single-sided) 62
- Weight and sizes 64
- Guidelines for heavy paper 64
- Setting custom paper sizes 65
- Using printer driver features 70
- Printing a watermark 71
- Using job-storage features 72
- Deleting a quick copy job 73
- Proofing and holding a job 73
- * appears in place of 74
- Storing a print job 76
- Deleting a stored job 76
- Managing and maintaining the 77
- Using the embedded Web server 78
- Information pages 79
- Settings pages 80
- Network pages 80
- Configuring e-mail alerts 81
- Managing the print cartridge 82
- Checking the supply level 83
- ORDER CARTRIDGE 84
- Menu map 85
- Configuration page 85
- Supplies status page 87
- PS or PCL font list 88
- Cleaning the printer 89
- Cleaning the fuser 91
- ON, and then press SELECT () 92
- Replacing the stapler unit 94
- Problem solving 97
- Clearing jams 98
- CARTRIDGE DETECTED 100
- Clearing jams from the trays 102
- Solving repeated paper jams 110
- ELP ( ) again 111
- Control panel messages 112
- 50.5 FUSER ERROR 113
- 112 4 Problem solving ENWW 114
- X and Y are as follows: 114
- ELECT ( ) to continue 116
- 116 4 Problem solving ENWW 118
- 118 4 Problem solving ENWW 120
- 120 4 Problem solving ENWW 122
- XX] to clear the message 122
- Mopy disk error messages 123
- Accessory lights 124
- Light print (partial page) 127
- Light print (entire page) 127
- Dropouts 128
- Gray background 128
- Toner smear 129
- Loose toner 129
- Repeating defects 129
- Repeating image 130
- Misformed characters 130
- Page skew 130
- Curl or wave 130
- Wrinkles or creases 131
- Vertical white lines 131
- Tire tracks 131
- White spots on black 131
- Scattered lines 132
- Blurred print 132
- Determining printer problems 133
- 132 4 Problem solving ENWW 134
- READY or 134
- PS for this print job only 135
- 134 4 Problem solving ENWW 136
- 136 4 Problem solving ENWW 138
- Selecting an alternate PPD 140
- You receive this 141
- Troubleshooting PS errors 142
- 142 4 Problem solving ENWW 144
- Service and support 145
- Contacting HP 146
- HP service agreements 147
- HP SupportPacks 147
- Warranty information 148
- Service information form 151
- HP software license terms 152
- Control panel menus 153
- Retrieve Job menu 154
- Information menu 155
- Paper Handling menu 156
- ENWW Paper Handling menu 155 157
- Item Values Explanation 157
- Configure Device menu 159
- PCL submenu 160
- Print Quality submenu 161
- System Setup submenu 164
- ELECT () 165
- ELECT ( ) before each job to 165
- Output Setup submenu 166
- I/O submenu 167
- Resets submenu 168
- Diagnostics menu 169
- Service menu 169
- Printer memory and expansion 171
- Installing memory 172
- Checking memory installation 174
- Printer commands 177
- Combining escape sequences 178
- Entering escape characters 179
- Function Command Options (#) 181
- Specifications 183
- Paper specifications 184
- ENWW Paper specifications 183 185
- Size Dimensions 185
- Weight Capacity 185
- ENWW Paper specifications 185 187
- Size Dimensions Weight 187
- Supported types of paper 189
- Guidelines for using paper 189
- Transparencies 192
- Envelopes 193
- Card stock and heavy paper 194
- Printer specifications 195
- Environmental specifications 196
- General specifications 197
- Regulatory information 199
- Material restrictions 201
- Material Safety Data Sheet 201
- For more information 201
- Declarations of Conformity 202
- Safety statements 203
- Laser statement (Finland) 204
- ENWW Index 203 205
- Numerics 205
- 204 Index ENWW 206
- ENWW Index 205 207
- 206 Index ENWW 208
- ENWW Index 207 209
- 208 Index ENWW 210
- ENWW Index 209 211
- 210 Index ENWW 212
- ENWW Index 211 213
- 212 Index ENWW 214
- ENWW Index 213 215
- 214 Index ENWW 216
- Hewlett-Packard Company 218
Verwandte Produkte und Handbücher für Laser- / LED-Drucker HP LaserJet 4300 Series
Laser- / LED-Drucker HP 9040 Betriebsanweisung
(330 Seiten)
(330 Seiten)
Laser- / LED-Drucker HP 9040 CE Betriebsanweisung
(288 Seiten)
(288 Seiten)
(256 Seiten)
Laser- / LED-Drucker HP au-Series Betriebsanweisung
(338 Seiten)
(338 Seiten)
Laser- / LED-Drucker HP ENWW Betriebsanweisung
(252 Seiten)
(252 Seiten)
(101 Seiten)
(82 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.840 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern