Hp ESL E-series Tape Libraries Bedienungsanleitung PDF herunterladen (Seite 20)

CAUTION:

SDLT tape drives require special cleaning cartridges and data cartridges formatted specifically for

SDLT. To avoid damage to your tape drive, it is critical to use appropriate cleaning cartridges, and

properly formatted data cartridges. Do not use DLT Tape I, DLT Tape II, DLT Tape III, or DLT Tape IIIXT

data cartridges, or DLT cleaning cartridges with SDLT tape drives.

Make it a practice to visually inspect your tape cartridges when loading or removing them from your

tape library. Taking a few minutes to check the condition of your cartridges will lower the risk of

repeated failures and help ensure uninterrupted backup.

CAUTION:

Always discard damaged tape cartridges. If a defective tape cartridge is loaded into a tape drive it

may damage the drive, potentially requiring drive replacement.

NOTE:

For information on ordering tape cartridges and barcode labels, see the

HP StorageWorks Tape

Libraries Media and Barcode Labels

flyer that shipped with your library. You can also access this

information at http://www.hp.com/go/storagemedia.

Load ports and magazines

The load ports are mechanical devices in the front panel of the library that enable you to import or

export tape cartridges to and from the library via three columns of tape cartridge magazines, two

magazines per column, without interrupting library operations. Removable magazines are available

for both the left and right load ports with either SDLT or LTO slots.

There are 2 tape cartridge magazines in the left load port, and 4 in the right (see Figure 7). The

number of tape cartridges in these magazines differs between the SDLT and LTO libraries. To find the

number of tape cartridges for any configuration, use the tables located in Library storage locations

and slot numbering

Library overview20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 175 176

Keine Kommentare

Hp ESL E-series Tape Libraries Bedienungsanleitung Seite 20