HP Digital AlphaStation 255 Family Technical Information PDF herunterladen (Seite 235)

The elements of the sample dial string and alert string are shown in Table 7–3. Paging

services vary, so you need to become familiar with the options provided by the paging

service you will be using. The RMC supports only numeric messages.

Sets the string to be used by the RMC to dial out when an alert condition occurs. The dial

string must include the appropriate modem commands to dial the number.

Sets the alert string, typically the phone number of the modem connected to the remote

system. The alert string is appended after the dial string, and the combined string is sent to

the modem when an alert condition is detected.

Enables remote access to the RMC’s modem port.

Clears current alert condition

Enables the RMC to page a remote system operator.

Forces an alert condition. This command is used to test the setup of the dial-out alert

function. It should be issued from the local serial terminal or local VGA monitor. As long as

no one connects to the modem and there is no other alert pending, this alert will be sent to the

pager as soon as the modem is connected to the system. If the pager does not receive the

alert, re-check your setup.

Status of the RMC configuration.

NOTE: If you do not want dial-out paging enabled at this time, enter the disable alert

command after you have tested the dial-out alert function. Alerts continue to be

logged, but no paging occurs.

Using the Remote Management Console 7-27

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 352 353

Keine Kommentare

HP Digital AlphaStation 255 Family Technical Information Seite 235