HP xw8600 Workstation Spezifikationen Seite 150
- Seite / 180
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Screen message Probable cause Recommended action
207—Incompatible memory
modules detected
Single-bit ECC error. 1. Verify the memory module type.
2. Insert the DIMM in another memory socket.
3. Replace the memory module if the problem
persists.
208—Two-DIMM
configurations use slots one
and five
DIMMs are loaded in incorrect slots for
a two-DIMM configuration.
Verify that the two DIMMs are installed in slots one and
five only.
209—Incompatible memory
(FBDs) detected
Incorrect memory module type in use. Verify that the memory modules are compatible with
workstation requirements.
210—Mismatched memory
(AMBs) detected
Different memory module types are
matched.
Verify that compatible memory module types are used
in matched pairs.
211—Memory warning
condition detected
Improper or defective memory module. Replace the memory module.
212—Failed Processor Processor has failed to initialize. 1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
213—Incompatible Memory
Modules
A memory module in the memory
socket identified in the error message
is missing critical SPD information, or
is incompatible with the chipset.
1. Verify the memory module type.
2. Insert the DIMM in another memory socket.
3. Replace the module with a DIM conforming to the
SPD standard.
214—DIMM Configuration
Warning
DIMMs are not installed correctly (not
paired correctly).
See the service label on the workstation access panel
for the correct memory configurations, and reseat the
DIMMs accordingly.
216—Memory Size Exceeds
Maximum Supported
The amount of memory installed
exceeds that supported by the
hardware.
1. Verify how much memory your system supports.
2. Remove the excess memory.
301—Keyboard Error Keyboard failure. 1. Reconnect the keyboard with the workstation
powered off.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace the keyboard.
303—Keyboard Controller
Error
I/O board keyboard controller is
defective or is not set properly.
1. Reconnect the keyboard with the workstation
powered off.
2. Replace the system board.
304—Keyboard or System
Unit Error
Keyboard failure. 1. Reconnect the keyboard with the workstation
powered off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
510—Splash Screen image
corrupted
Splash Screen image has errors. Update system BIOS.
Table 5-18 POST error messages (continued)
140 Chapter 5 System diagnostics and troubleshooting ENWW
- HP xw8600 Workstation 1
- Table of contents 3
- 1 Product overview 11
- System board architecture 12
- Workstation components 12
- ENWW Product features 3 13
- Front panel components 14
- Rear panel components 15
- Maximizing airflow 16
- Workstation specifications 17
- Power supply specifications 18
- System fans 19
- ENERGY STAR Qualification 20
- HP Cool Tools 22
- Configuring the software 23
- Selecting a language 23
- Creating recovery disks 24
- Ordering backup software 25
- The RestorePlus! process 27
- Protecting your software 30
- Setting up Red Hat Linux 30
- Linux-enabled workstations 32
- 3 System management 33
- BIOS ROM 34
- Workstation management 41
- Installing a remote system 42
- Replicating the setup 43
- HP Client Manager Software 44
- System Software Manager 45
- Proactive Change Notification 45
- Subscriber’s Choice 45
- ROM Flash 46
- Asset tracking and security 47
- Password security 48
- DriveLock 51
- Cable lock (optional) 54
- Drive Protection System 54
- ECC fault prediction 54
- Dual-state power button 55
- Warnings and cautions 57
- Service considerations 58
- Table 4-1 Static electricity 59
- Grounding the work area 60
- Cables and connectors 61
- Hard drives 61
- Lithium coin cell battery 61
- Customer Self-Repair 62
- Predisassembly procedures 62
- System board components 62
- Disassembly order 63
- Removing the cable lock 66
- Side access panel 67
- Removing the Hood Sensor 68
- Front bezel 69
- Bezel blanks 70
- Power button assembly 73
- Optical drive 74
- Removing an optical drive 75
- Installing an optical drive 76
- System speaker 78
- Power supply 79
- Installing the power supply 80
- Memory general information 82
- System board memory 84
- Memory riser assembly 87
- PCI card slots 95
- Slot lane redirection 96
- PCI card support 100
- Installing a PCI card support 101
- PCI Express cards 102
- Installing a PCI Express card 104
- PCI card 105
- Removing the battery 106
- SAS hard drive 107
- Installing a SAS hard drive 108
- SATA hard drive 111
- Installing a SATA hard drive 112
- Processor heatsink 116
- System processor 118
- Installing a system processor 119
- System board 120
- Removing the system board 121
- Product recycling 122
- 5 System diagnostics and 123
- Diagnostic LED codes 124
- ENWW Customer Self Help 115 125
- Solving minor problems 126
- ENWW Customer Self Help 117 127
- Solving power supply problems 128
- Solving diskette problems 130
- ENWW Customer Self Help 121 131
- Solving hard drive problems 132
- Solving display problems 133
- Solving audio problems 135
- Solving printer problems 136
- ENWW Customer Self Help 127 137
- Solving network problems 139
- Solving memory problems 140
- Solving processor problems 141
- Solving DVD problems 141
- ENWW Customer Self Help 133 143
- Troubleshooting checklist 144
- LED color definitions 144
- Key features and benefits 145
- Theory of operation 145
- Diagnostic utility on CD 145
- User Interface 146
- Status tab 147
- POST error messages 148
- ENWW POST error messages 139 149
- ENWW POST error messages 141 151
- ENWW POST error messages 143 153
- 6 Configuring RAID devices 155
- SAS RAID 0 configuration 156
- SAS RAID 1 configuration 156
- Configuring SATA RAID devices 157
- Attaching SATA HDDs 158
- Configuring system BIOS 158
- Creating RAID volumes 159
- Deleting RAID volumes 159
- Resetting the password jumper 162
- A Appendix A—Connector pins 165
- B Appendix B—System board 177
- C Appendix C—Routine care 179
- Cleaning the monitor 180
- Cleaning the mouse 180
Verwandte Produkte und Handbücher für PC / Workstation Barebones HP xw8600 Workstation
(4 Seiten)
(92 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.102 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern