HP xw8600 Workstation Spezifikationen Seite 141

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 180
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 140
Problem Cause Solution
Out of memory error.
Memory configuration might
not be set up correctly.
Verify proper workstation memory configuration. (See
Memory on page 72.)
You have run out of memory to
run the application.
Review the application documentation to determine the
memory requirements.
Memory count during POST is
wrong.
The memory modules might
not be installed correctly.
Verify that the memory modules are installed correctly and
that proper modules are used.
Insufficient memory error during
operation.
Too many Terminate and Stay
Resident (TSR) programs are
installed.
Delete TSRs that you do not need.
You have run out of memory
for the application.
Verify the memory requirements for the application or add
more memory to the workstation.
Power LED flashes red 5 times
(once every second), followed by a
2-second pause, and then the
workstation beeps 5 times.
Memory is installed incorrectly
or is bad.
1. Reseat DIMMs.
2. Replace DIMMs one at a time to isolate the faulty
module.
3. Replace third-party memory with HP memory.
4. Replace the system board.
Solving processor problems
Table 5-14 Processor problems
Problem Cause Solution
Poor performance is experienced. Processor is hot. 1. Be sure the airflow to the workstation is not blocked.
2. Be sure the fans are connected and working properly.
Some fans only operate when needed.
3. Be sure the processor heatsink is installed properly.
Power LED is red and stays on. Processor is not seated
properly or is not installed.
1. Verify that the processor is present.
2. Reseat the processor.
Solving DVD problems
Table 5-15 DVD problems
Problem Cause Solution
System does not boot from DVD
drive.
The DVD boot is not enabled
through the Computer Setup
(F10) Utility.
Run the Computer Setup (F10) Utility and enable booting
to removable media and verify boot order settings.
Nonbootable CD in drive. Try a bootable DVD in the drive.
DVD devices are not detected or
the driver is not loaded.
Drive is not connected properly
or not properly configured.
1. Reconnect power and data cables to the drive.
2. Install correct device driver.
Table 5-13 Memory problems (continued)
ENWW Customer Self Help 131
Seitenansicht 140
1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 179 180

Kommentare zu diesen Handbüchern

Keine Kommentare