HP xw8600 Workstation Spezifikationen PDF herunterladen (Seite 119)

4. Raise the processor socket lever (1) and open the cover (2) as shown in the following figure.

Figure 4-73 Removing the system processor

CAUTION: Do not touch the processor socket contacts or the gold pads underneath the

processor. Use extreme care and handle the processor only by the edges.

5. Pull the processor straight out of the socket (3), and store the processor in a static free container

in a safe place where it cannot be damaged

Installing a system processor

NOTE: If installing a second processor, it must be of the same type as the first processor.

1. Disconnect power from the system (see Predisassembly procedures on page 52).

2. Remove the side access panel (see

Removing the side access panel on page 57).

3. Remove the processor heatsink (see

Removing the processor heatsink on page 106).

4. Remove the processor (see

Removing a system processor on page 108).

5. Using extreme care, fully raise the processor socket lever and cover.

CAUTION: The processor socket contacts are delicate. To avoid bending the contacts, use

extreme care when installing the processor in the socket.

6. If you are adding a second processor to a single-processor system:

●

Remove the plastic cover from the second processor socket.

ENWW Removing and replacing components 109

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 179 180

Keine Kommentare

HP xw8600 Workstation Spezifikationen Seite 119