Hp RP3440 Bedienungsanleitung PDF herunterladen (Seite 78)

4. Push in on the power supply release lever to lock the retaining clip in place.

5. Replace the front bezel. (See “Removing and Replacing the Front Bezel on a Pedestal-Mounted

Server” (page 60).)

6. Verify that both power supply LEDs are lit.

7. Use the iLO MP PS command to verify power supply operation.

Installing an Additional Processor Module

This section provides information about installing dual processor modules. The modules are

located on the system board which is accessible by removing the server cover.

The HP 9000 rp3410 server supports one processor socket. This socket accepts one dual processor

module which contains two 800 MHz CPUs. The HP 9000 rp3410 server 1P/1C configuration

includes two CPUs in a single module, but only one CPU is enabled. The second CPU can be

enabled as part of a server upgrade.

The HP 9000 rp3440 server supports two processor sockets. Each socket accepts one dual processor

module which contains either two 800 MHz CPUs or two 1 GHz CPUs.

WARNING! Ensure that the server is powered off and all the power sources have been

disconnected from the server before removing or replacing a dual processor module.

Voltages are present at various locations within the server whenever an AC power source is

connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning can result in personal injury or damage to equipment.

CAUTION: Failure to properly complete the steps in this procedure will result in erratic server

behavior or system failure. For assistance with this procedure contact your local HP Authorized

Service Provider.

Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety

precautions can result in damage to the server.

NOTE: Processor tool kit (HP part number 5069-5441) is required for installation of a processor

module.

Processor modules are located on the system board. The system board can support either one or

two dual processor modules. The CPU0 socket is located at the right of the system board and

the CPU1 socket is located at the left of the system board next to the bridge assembly. In a 1P/1C,

1P/2C server, the single dual processor module must be installed in the CPU0 socket.

To install a second dual processor module, follow these steps:

1. Power off the server and disconnect all the power and external cables.

2. Remove the cover. (See “Removing and Replacing Server Covers and Bezels” (page 52).)

3. Remove the memory airflow guide. (See “Replacing the Memory Airflow Guide” (page 66).)

4. Remove the processor airflow guide. (See “Removing the Processor Airflow Guide”

(page 66).)

78 Installing the System

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 209 210

Keine Kommentare

Hp RP3440 Bedienungsanleitung Seite 78