Hp RP3440 Bedienungsanleitung PDF herunterladen (Seite 167)

6. Verify the battery replacement and operation by using the system utilities. (For additional

information, see Appendix B (page 199) or the HP Integrity and HP 9000 iLO MP Operations

Guide.)

• Use the iLO MP commands to verify operation.

• Use the BCH commands to verify operation.

7. You must reset the system time and date using the BCH DATE command. Once you have

set the time, turn the server off, unplug the power cord, and wait for a minute before turning

it back on. Execute the DATE command again. If the time and date are now correct, you have

installed the battery correctly.

8. Reset the LAN configuration settings, boot settings, or any other system settings.

Removing and Replacing the PCI Card Cage

PCI cards are installed in a removable PCI card cage. This section explains how to access the PCI

card cage, as well as how to remove and install PCI cards.

Removing the PCI Card Cage

To remove the PCI card cage from the server, follow these steps:

WARNING! Ensure that the server is powered off and all the power sources have been

disconnected from the server before removing or replacing a PCI card cage.

Voltages are present at various locations within the server whenever an AC power source is

connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning can result in personal injury or damage to equipment.

To remove the PCI card cage, follow these steps:

1. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” (page 126).)

2. Disconnect cables from the PCI cards.

3. Lift up on the PCI card cage release lever and the back edge of the PCI card cage and lift the

PCI card cage out of the server (Figure 6-54).

Removing and Replacing the PCI Card Cage 167

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 209 210

Keine Kommentare

Hp RP3440 Bedienungsanleitung Seite 167