Hp RP3440 Bedienungsanleitung PDF herunterladen (Seite 177)

2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” (page 126).)

3. Disconnect the LED status panel controller cable.

4. Unscrew the two LED status panel mounting screws and remove the panel.

Figure 6-63 Removing the LED Status Panel

Replacing the LED Status Panel

To replace the LED status panel, follow these steps:

1. Replace the LED status panel in the server and screw in the two LED status panel mounting

screws.

2. Connect the LED status panel controller cable.

3. Replace the top cover.

4. Reconnect all the power and external cables.

5. Turn on the server and verify that the server and power LEDs light up.

Removing and Replacing the System Board

Server information is stored on the system board. If you are installing a new system board, you

must write the serial number and model string information to the system board after installation.

Removing the System Board

To remove the system board, follow these steps:

1. Power off the server and disconnect all the power and external cables.

2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” (page 126).)

3. Remove these components from the system board:

• System fans. (See “Removing a System Fan” (page 136))

• PCI card cage. (See “Removing the PCI Card Cage” (page 167))

• Memory airflow guide. (See “Removing the Memory Airflow Guide” (page 144))

• Processor airflow guide. (See “Removing the Processor Airflow Guide” (page 145))

Removing and Replacing the System Board 177

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 209 210

Keine Kommentare

Hp RP3440 Bedienungsanleitung Seite 177