Hp Hitachi Dynamic Link Manager Software Bedienungsanleitung Seite 406

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 746
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 405
4. HDLM Operation
382
Legend:
a: Host ID (Port number of the host)
b: Channel number (Bus number)
c: Target ID
d: Lun (LU number of the host)
n: host port number
driver-name:
qlaxxxx (driver name in use)
An example entry is shown below.
When adding a device by using a QLogic HBA driver in Red Hat Enterprise
Linux AS4/ES4:
# echo "scsi-qlascan" > /proc/scsi/qla2200/1
# cat /proc/scsi/qla2200/1
# echo "scsi add-single-device 1 0 1 1" > /proc/scsi/scsi
4. Wait until the automatic failback function starts, or execute the dlnkmgr
command (
dlnkmgr online -pathid AutoPATH_ID).
The relevant path is placed online.
The following is an example of executing the HDLM command:
# /opt/DynamicLinkManager/bin/dlnkmgr online -pathid
AutoPATH_ID
5. Refer to
/var/opt/DynamicLinkManager/log/dlmcfgmgr1.log or
execute the
dlmcfgmgr utility (dlmcfgmgr -v) to check if the path to the
relevant HDLM device is restored.
The following is an example of executing the
dlmcfgmgr utility:
# /sbin/dlmcfgmgr -v
(10) Restoring the Path in Disconnected Status
This subsection describes how to restore the path to an HDLM device that was in
disconnected status (the cable was pulled out or broken).
1. Execute the HDLM-configuration definition utility (
dlmcfgmgr -v) to check
while the path to the relevant HDLM device was in disconnected status.
The following are examples of executing the command:
# /sbin/dlmcfgmgr -v
Seitenansicht 405
1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 745 746

Kommentare zu diesen Handbüchern

Keine Kommentare