HP 690n Betriebsanweisung PDF herunterladen (Seite 47)

If your HP-UX system does not provide DDNS services for its DHCP implementation, HP recommends

that you set all print server lease durations to infinite. This ensures that print server IP addresses remain

static until dynamic domain name services are available.

Windows systems

HP Jetdirect print servers support IP configuration from a supported Windows DHCP server. This section

describes how to set up a pool or scope of IP addresses that the Windows server can assign or lease to

any requester. When configured for BOOTP or DHCP operation and turned on, the HP Jetdirect print

server automatically sends a BOOTP or DHCP request for its IP configuration. If properly set up, a

Windows DHCP server responds with the print server's IP configuration data.

NOTE: For specific topics or for additional support, see the information supplied with your DHCP

server software.

To avoid problems resulting from changing IP addresses, HP recommends assigning printers IP

addresses with infinite lease durations or using reserved IP addresses.

Windows Server 2003 and Server 2008

To set up a DHCP(IPv4) scope on a Windows Server 2003 or Server 2008 system, perform the

following steps:

Run the Windows DHCP manager utility.

2. Click Start, and then click Control Panel. Open the Administrative Tools folder and run the

DHCP utility.

3. In the DHCP window, locate and select your Windows server in the DHCP tree.

If your server is not listed, select DHCP and click the Action menu to add the server.

4. Select your server in the DHCP tree, click the Action menu, and then select New Scope. This

runs the Add New Scope Wizard.

5. In the Add New Scope Wizard, click Next.

6. Enter a Name and Description for this scope, then click Next.

Enter the range of IP addresses for this scope (beginning and ending IP address), type the subnet

mask, and then click Next.

NOTE: If subnetting is used, the subnet mask defines which portion of an IP address specifies the

subnet and which portion specifies the client device.

If applicable, type the range of IP addresses within the scope to be excluded by the server, and

then click Next.

9. Set the IP address lease duration for your DHCP clients, and then click Next.

HP recommends that all printers be assigned reserved IP addresses. Do this after setting up the

scope (see step 11).

10. Select No to configure DHCP options for this scope later, and then click Next.

IPv4 configuration

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 205 206

Keine Kommentare

HP 690n Betriebsanweisung Seite 47