HP 690n Betriebsanweisung PDF herunterladen (Seite 167)

Table 8-14 Error messages (continued)

Error Code and Message Description

64 INVALID PASSWORD An invalid password was specified through TFTP. Verify that the password consists of a

maximum of 16 printable characters.

65 DOWNLOAD NOT ALLOWED

ON WIRELESS

This print server does not allow firmware upgrade over a wireless network connection.

83 DISCONNECTING FROM

SERVER

Server shut down because of a configuration change or reset request. This message

automatically clears after a few seconds, unless the printer is offline, is in an error

state, or is servicing another I/O port or another network protocol.

84 DHCP LEASE TIMERS ADJUSTED The print server detected a DHCP lease error due to one of the following conditions:

●

Renew time is less than 30 seconds.

●

Rebind time is less than 52 seconds.

●

Rebind time is less than, or equal to, the Renew time.

●

Lease duration is less than, or equal to, the Rebind time.

F1 TRYING TO CONNECT TO

SERVER

The HP Jetdirect print server is attempting connection to the NetWare server(s). This is a

normal message. Wait until the connection is established or another status message

appears.

F2 TFTP IN PROGRESS The print server is attempting to use TFTP to obtain TCP/IP configuration settings over

the network.

F3 BOOTP/RARP IN PROGRESS The print server is attempting to use BootP or RARP to obtain TCP/IP configuration

settings over the network.

F4 BOOTP/DHCP IN PROGRESS The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration

settings over the network.

HP Jetdirect Security page

If the HP Jetdirect print server supports IPsec, you can print an enhanced Security page from the

HP Jetdirect menu that is accessed through the printer control panel. The following figure shows a

typical Security page:

NOTE: This section describes a typical security page. The actual security page content depends on

the HP Jetdirect product and the firmware version.

To print the HP Jetdirect Security Page:

On the printer control panel, navigate to the HP Jetdirect menus.

In the HP Jetdirect menus, locate and select the Security menu item.

In the Security menu, locate and select Print Sec Page. (This option is displayed only if IPsec is

supported by the print server.)

Click Yes to print the security page.

HP Jetdirect Security page

157

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 690n Betriebsanweisung Seite 167

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung HP 690n