HP DT-10 Bedienungsanleitung

SmartShare® User Manual User Manual RM-20, RM-50, RM-100, RM-200, RM-500, RM-1000 DT-5, DT-10, DT-20, DT-50 Firmware: 1.11

SmartShare® User Manual – 9 – Internet/WAN (Wide Area Network) configuration menu The Internet service provider usually supplies all the information t

SmartShare® User Manual – 10 – External Servers (optional) NTP Server If the system time must be synchronized with an external NTP server, its host na

SmartShare® User Manual – 11 – NAPT (Network Address and Port Translation) configuration menu Port Forwarding to Local Servers These fields can be con

SmartShare® User Manual – 12 – Advanced configuration menu Remote Management The built-in web based setup menu can be changed to a different port. The

SmartShare® User Manual – 13 – Outgoing SMTP Connections The SmartShare has 4 different modes for handling outgoing SMTP (TCP port 25) connections fro

SmartShare® User Manual – 14 – Bandwidth User Groups Bandwidth User Groups can be used to configure which IP address ranges the bandwidth manager cont

SmartShare® User Manual – 15 – System menu Download Firmware The SmartShare firmware can be upgraded from the firmware server at SmartShare Systems or

SmartShare® User Manual – 16 – Managers configuration menu Multiple users can manage and configure the SmartShare. The following can be configured fo

SmartShare® User Manual – 17 – Security Considerations Physical Access The SmartShare should be installed in a locked patch panel. Anyone with physica

SmartShare® User Manual – 18 – Q: After powering on the SmartShare, the WAN connection to the ISP is not established. A: First, verify that everything

SmartShare® User Manual – 1 – Introduction The SmartShare® is an integrated bandwidth manager and NAT router with built-in DHCP server and optional an

SmartShare® User Manual – 19 – LED Indicators The two LEDs for each LAN/WAN/Ext1/Ext2 Ethernet port indicate as follows: LINK/ACT = Off No connection

SmartShare® User Manual – 2 – Table of Contents Introduction ...

SmartShare® User Manual – 3 – DHCP Proxy ...

SmartShare® User Manual – 4 – Installation Guide 1. Connect to the local network equipment Connect the LAN port on the SmartShare to any Ethernet port

SmartShare® User Manual – 5 – The SmartShare Bandwidth Management System This section describes the SmartShare bandwidth management system in details,

SmartShare® User Manual – 6 – Dynamic Quality of Service The SmartShare always prioritizes timing critical traffic flows, such as IP telephony and onl

SmartShare® User Manual – 7 – Status menu This page shows the current status of the Internet connection. System This shows system status, such as the

SmartShare® User Manual – 8 – When the download bandwidth becomes overloaded, the SmartShare starts restricting the heavy users by activating the Down