HP 690n Betriebsanweisung PDF herunterladen (Seite 166)

Table 8-14 Error messages (continued)

Error Code and Message Description

50 TFTP LOCAL ERROR TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed.

The local print server encountered an inactivity timeout or excessive retransmission

situation.

51 TFTP RETRIES EXCEEDED Retry limit exceeded when transferring the TFTP configuration file from the host to the

HP Jetdirect print server.

52 BAD BOOTP/DHCP REPLY Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server.

The reply contains insufficient data in the UDP datagram for the minimum BOOTP/

DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02), has

a header field that does not match the print servers hardware address, or contains a

UDP source port that is not the BOOTP/DHCP server port (67/udp).

53 BAD BOOTP TAG SIZE Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the

remaining number of unprocessed bytes in the vendor-specified area.

54 BOOTP/RARP IN PROGRESS Print server is obtaining its basic IP configuration information through BOOTP/RARP.

55 BOOTP/DHCP IN PROGRESS HP Jetdirect print server is obtaining its basic IP configuration information through

BOOTP/DHCP (no errors detected).

56 DHCP NAK Print server received a negative acknowledgement message from the DHCP server in

response to a configuration request.

57 UNABLE TO CONNECT DHCP

SVR

The HP Jetdirect print server received IP parameters from a DHCP server, but

communication with the server is lost. Check status of the DHCP server.

If an infinite lease is assigned, the print server uses the IP address of the most recent

DHCP server. Operation can degrade until a DHCP server responds.

58 POSTSCRIPT MODE NOT

SELECTED

Printer does not support AppleTalk or AppleTalk extensions.

59 INCOMPLETE F/W - MUST

DOWNLOAD

Currently downloading firmware to the HP Jetdirect print server, or the download did

not complete properly.

5A TURN PRINTER OFF / ON Firmware download is complete. Turn the HP Jetdirect print server off and then on.

5C DHCP BAD REPLY Bad reply received from the DHCP server. Check your DHCP server settings for this

print server.

5D DHCP LEASE DURATION TOO

SHORT

DHCP lease times for this print server's TCP/IP configuration settings are too short. Re-

configure the DHCP lease times on the DHCP server.

5E DHCP LEASE RELEASED Lease parameters for DHCP, including the IP address, were released through a manual

configuration method, such as the printer's control panel.

5F WINS REGISTRATION FAILED Cannot register the print server's name on the WINS server. Check for duplicate

names, or verify the WINS server configuration.

61 AUTO IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to an IP

address using link-local addressing in the form 169.254.x.x.

62 DEFAULT IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to a legacy IP

address 192.0.0.192.

63 AUTO IP IN PROGRESS The print server is automatically assigning an IP address using link-local addressing in

the form 169.254.x.x.

156 Chapter 8 HP Jetdirect configuration pages

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 690n Betriebsanweisung Seite 166

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung HP 690n