HP 690n Betriebsanweisung PDF herunterladen (Seite 194)

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item Sub-menu item Sub-menu item Values and Description

RTT Average Average RTT, from 0 to 4096 milliseconds, for packet

transmission and response.

Ping in Progress Yes a test is in progress. No a test completed or is not

running.

Refresh Update the ping test data with current results.

Yes: Update the data.

No: Maintain the existing data. (Automatically

refreshes when the menu times out or you manually

return to the main menu.)

Link Speed Set the print server's link speed. The available settings

depend on the device and installed print server. Select

one of the following modes:

Auto (default): Use auto-negotiation to configure the

highest link speed and communication mode allowed.

If auto-negotiation fails, either 100TX HALF or 10TX

HALF is set depending on the detected link speed of

the hub/switch port. (A 1000T half-duplex selection is

not supported.)

10T Half: 10 Mbps, half-duplex operation.

10T Full: 10 Mbps, full-duplex operation.

100TX Half: 100 Mbps, half-duplex operation.

100TX Full: 100 Mbps, full-duplex operation.

100TX Auto: Limits auto-negotiation to a maximum link

speed of 100 Mbps on 1000T networks.

1000TX Full: 1000 Mbps, full-duplex operation.

CAUTION: Changing the link setting can cause the

loss of network communication with the print server.

Print Protocols Print a page that lists the configuration of the following

protocols: IPX/SPX, Novell NetWare, AppleTalk,

DLC/LLC.

184 Appendix C HP Jetdirect control panel menus (V.40.xx)

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 205 206

Keine Kommentare

HP 690n Betriebsanweisung Seite 194