HP 690n Betriebsanweisung Seite 31

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 206
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 30
limited subset of the configuration parameters, control panel configuration is recommended only
during troubleshooting or for simple installations. If control panel configuration is used, the print
server saves the configuration when turned off and then turned on. For more information, see “
Use
the printer control panel on page 62”.
Use BOOTP/TFTP (IPv4)
BOOTP and TFTP provide a convenient way to automatically configure the HP Jetdirect print server for
TCP/IPv4 network operation. When turned on, the HP Jetdirect print server sends a BOOTP request
message onto the network. A properly configured BOOTP server on the network responds with a
message that contains basic network configuration data for the HP Jetdirect print server. The BOOTP
server's response can also identify a file (TFTP configuration file) that contains extended configuration
data for the print server. The HP Jetdirect print server uses TFTP to download this file from the BOOTP
server or from a separate TFTP server.
NOTE: If you are configuring an HP Jetdirect wireless print server, this section assumes that a wireless
network connection is established.
BOOTP/TFTP servers are typically UNIX or Linux systems. Windows Server 2003, Server 2008, and
NetWare servers can respond to BOOTP requests. Windows Server 2003 and Server 2008 servers
are configured through Microsoft DHCP services (see
Use DHCP (IPv4) on page 36). However,
Windows Server 2003 and Server 2008 systems might require third-party software for TFTP support.
For setup of NetWare BOOTP servers, see the NetWare documentation.
NOTE: If the HP Jetdirect print server and BOOTP/DHCP server are located on different subnets, IPv4
configuration might fail unless the routing device supports BOOTP Relay, which allows the transfer of
BOOTP requests between subnets.
Advantages of using BOOTP/TFTP
Using BOOTP/TFTP to download configuration data has the following benefits:
Enhanced configuration control of the HP Jetdirect print server. Configuration by other methods,
such as a printer control panel, are limited to select parameters.
Ease of configuration management. Network configuration parameters for the entire network are
in one location.
Ease of HP Jetdirect print server configuration. Complete network configuration is automatically
downloaded each time the print server is turned on.
NOTE: BOOTP operation is similar to DHCP, but the resulting IP parameters are the same when
turned off and then turned on. In DHCP, IP configuration parameters are leased and might change over
time.
When in its factory-default state and turned on, the HP Jetdirect print server attempts to automatically
configure itself using several dynamic methods, including BOOTP.
Configure the print server using BOOTP/TFTP on UNIX
This section describes how to configure the print server using BOOTP and TFTP services on UNIX
servers. Use BOOTP and TFTP to download network configuration data from a server to the HP Jetdirect
print server over the network.
IPv4 configuration
21
Seitenansicht 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare