Hp Officejet J5740 All-in-One Printer Bedienungsanleitung PDF herunterladen (Seite 194)

check the sound quality of the phone line by plugging a phone into the telephone wall

jack and listening for static or other noise. If the problem persists, turn Error

Correction Mode (ECM) off and contact your telephone company.

If the problem persists, check to see if Error Correction Mode (ECM) is On. If it is

not, change the ECM setting to On. Faxes might take longer to send, but the print

quality of the received fax should improve.

If the print quality is still poor, turn off ECM, and then contact your telephone provider.

To change the ECM setting from the control panel

1. Press Setup.

2. Press 5, and then press 6.

This selects Advanced Fax Setup and then selects Error Correction Mode.

3. Press

to select On or Off.

4. Press OK.

Cause: The fax resolution setting is set to a low resolution, such as Standard.

Solution: For the highest-quality fax, change the fax resolution to Fine, Very

Fine (if available), or Photo (for black-and-white photographs).

To change the resolution from the control panel

1. Load your originals print side up into the document feeder tray. If you are sending

a single-page fax, such as a photograph, you can also load your original print side

down on the glass.

NOTE: If you are sending a multiple-page fax, you must load the originals in

the document feeder tray. You cannot fax a multiple-page document from the

glass.

2. In the Fax area, press Menu.

The Enter Number prompt appears.

3. Enter the fax number by using the keypad, press Speed Dial or a one-touch speed

dial button to select a speed dial, or press Redial/Pause to redial the last number

dialed.

4. In the Fax area, press Menu repeatedly until Resolution appears.

5. Press

to select a resolution setting, and then press OK.

6. Press Start Fax Black.

• If the device detects an original loaded in the automatic document

feeder, the HP All-in-One sends the document to the number you entered.

• If the device does not detect an original loaded in the automatic

document feeder, the Fax from glass? prompt appears. Make sure your

original is loaded on the glass, and then press 1 to select Yes.

Cause: The glass of the HP All-in-One might be dirty.

Chapter 11

192 Troubleshooting

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 295 296

Keine Kommentare

Hp Officejet J5740 All-in-One Printer Bedienungsanleitung Seite 194