Hp Officejet J5740 All-in-One Printer Bedienungsanleitung PDF herunterladen (Seite 173)

The margins are not printing as expected

Cause: The margins are not set correctly in your software application.

Solution: Check the printer margins.

To check your margin settings

1. Preview your print job before sending it to the HP All-in-One.

2. Check the margins.

The HP All-in-One uses the margins you have set in your software application,

as long as they are greater than the minimum margins the HP All-in-One supports.

3. Cancel the print job if the margins are not satisfactory, and then adjust the margins

in your software application.

Make sure the margin settings for the document do not exceed the printable area of

the HP All-in-One.

Cause: The paper size setting might not be set correctly for the project you are

printing.

Solution: Verify that you have selected the proper paper size setting for your

project. Make sure that you have loaded the correct paper size in the input tray.

Cause: The paper guides are not positioned correctly.

Solution: Remove the stack of paper from the input tray, and then reload the paper

following the steps below.

To load full-size paper

1. Remove the output tray.

Print troubleshooting 171

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 295 296

Keine Kommentare

Hp Officejet J5740 All-in-One Printer Bedienungsanleitung Seite 173