Hp Officejet J5740 All-in-One Printer Bedienungsanleitung PDF herunterladen (Seite 203)

labeled 2-EXT, as shown below. You also need to set the correct number of rings to

answer for both the answering machine and HP All-in-One.

1 Telephone wall jack

2 Connect to the IN port on the answering machine

3 Connect to the OUT port on the answering machine

4 Telephone (optional)

5 Answering machine

6 Use the phone cord supplied in the box with the HP All-in-One

Make sure the HP All-in-One is set to receive faxes automatically and that the Rings

to Answer setting is correct. The number of rings to answer for the HP All-in-One

should be greater than the number of rings to answer for the answering machine. Set

your answering machine to a low number of rings and the HP All-in-One to answer

in the maximum number of rings supported by your device. (The maximum number

of rings varies by country/region.) In this setup, the answering machine will answer

the call and the HP All-in-One will monitor the line. If the HP All-in-One detects fax

tones, the HP All-in-One will receive the fax. If the call is a voice call, the answering

machine will record the incoming message.

To set the number of rings before answering from the control panel

1. Press Setup.

2. Press 4, and then press 3.

This selects Basic Fax Setup and then selects Rings to Answer.

3. Enter the appropriate number of rings by using the keypad, or press

or to

change the number of rings.

4. Press OK to accept the setting.

Fax troubleshooting 201

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 295 296

Keine Kommentare

Hp Officejet J5740 All-in-One Printer Bedienungsanleitung Seite 203