HP Compaq dc7900 USDT Spezifikationen Seite 218

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 300
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 217
4. Position the heatsink atop the processor.
5. If using a new heatsink, remove the protective covering from the bottom of the heatsink and place
it in position atop the processor.
6. Secure the heatsink to the system board and system board tray with the 4 captive screws and
attach the heatsink control cable to the system board.
CAUTION: Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an
X) to evenly seat the heatsink on the processor. This is especially important as the pins on the
socket are very fragile and any damage to them may require replacing the system board.
NOTE: After installing a new processor onto the system board, always update the system ROM to
ensure that the latest version of the BIOS is being used on the computer. The latest system BIOS can
be found on the Web at:
http://h18000.www1.hp.com/support/files.
System Board
CAUTION: Be very careful when removing or replacing the system board to prevent damaging it.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 178).
2. Remove the computer access panel (
Computer Access Panel on page 183).
3. Remove the optical drive (
Removing the Existing Optical Drive on page 191).
4. Remove the memory modules (
Installing Additional Memory on page 186).
5. Remove the hard drive (
Hard Drive on page 195).
6. Remove the hard drive cage (
Hard Drive Cage on page 199).
7. Remove the front I/O panel cage:
a. Remove the screw from the left side of the cage that holds the I/O panel cage in place (1).
b. Press the tab on left side of the cage (2), and then swing the cage toward right to remove it
from the chassis.
NOTE: If the cage sticks and will not come loose, press down on the top of the panel near
the tab while pressing the tab.
Figure 9-35 Removing the I/O panel cage
8. Remove the heatsink (Heatsink on page 204).
9. Disconnect all cables connected to the system board, noting their location for reinstallation.
206 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
Seitenansicht 217
1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 299 300

Kommentare zu diesen Handbüchern

Keine Kommentare