HP Compaq dc7900 USDT Spezifikationen PDF herunterladen (Seite 217)

CAUTION: Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an

X) to evenly seat the heatsink on the processor. This is especially important as the pins on the

socket are very fragile and any damage to them may require replacing the system board.

Processor

1. Prepare the computer for disassembly (Preparation for Disassembly on page 178).

2. Remove the computer access panel (

Computer Access Panel on page 183).

3. Remove the heatsink (

Heatsink on page 204).

4. Rotate the processor locking lever to its full open position (1).

5. Raise and rotate the microprocessor retainer to its fully open position (2).

6. Carefully lift the processor from the socket (3).

CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and

handling them could cause irreparable damage. Once pins are damaged it may be necessary to

replace the system board.

The heatsink must be installed within 24 hours of installing the processor to prevent damage to the

processor’s solder connections.

Figure 9-34 Removing the processor

To install a new processor:

1. Place the processor in its socket and close the retainer.

2. Secure the locking lever.

If reusing the existing heatsink, go to step 3.

If using a new heatsink, go to step 5.

3. If reusing the existing heatsink, clean bottom of the heatsink and apply the thermal grease provided

in the spares kit to the top of the processor.

Processor 205

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 299 300

Keine Kommentare

HP Compaq dc7900 USDT Spezifikationen Seite 217