HP Compaq dc7900 USDT Spezifikationen PDF herunterladen (Seite 181)

4. Apply the thermal grease provided in the spares kit to the top of the processor and install the

heatsink atop the processor.

5. Go to step 7.

6. If using a new heatsink, remove the protective covering from the bottom of the heatsink and place

it in position atop the processor.

7. Secure the heatsink to the system board and system board tray with the four captive screws and

attach the heatsink control cable to the system board.

CAUTION: Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an

X) to evenly seat the heatsink on the processor. This is especially important as the pins on the

socket are very fragile and any damage to them may require replacing the system board.

NOTE: After installing a new processor onto the system board, always update the system ROM to

ensure that the latest version of the BIOS is being used on the computer. The latest system BIOS can

be found on the Web at:

http://h18000.www1.hp.com/support/files.

Power Supply

WARNING! Voltage is always present on the system board when the computer is plugged into an

active AC outlet. To avoid possible personal injury and damage to the equipment the power cord should

be disconnected from the computer and/or the AC outlet before opening the computer.

1. Prepare the computer for disassembly (Preparation for Disassembly on page 118).

2. Remove the access panel (

Computer Access Panel on page 125).

3. Rotate the drive cage up and disconnect the power cables from all of the drives.

4. Disconnect the power cables from the system board.

5. Rotate the power supply to its full upright position.

6. Release the power supply cables from the cable retaining clips on the bottom of the chassis and

under the drive cage.

Figure 8-64 Cable routing

Power Supply 169

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 299 300

Keine Kommentare

HP Compaq dc7900 USDT Spezifikationen Seite 181