Hp StorageWorks XP10000 Disk Array Bedienungsanleitung PDF herunterladen (Seite 134)

• Name: Device name of the connected array. The device name can be changed. You can

use up to 180 alphanumeric characters for the device name; the following symbols cannot be

used: ", \,;,:,,,*,?,<,>, |,/,^,&,%,. Youcan useaspaceinthe middleof the device

name, but do not use a space before or after the device name.

NOTE:

Thedevicename isrequiredtouse SNMP Agent. Be sure to document the devicename because

the settings will be cleared when the SVP is replaced.

• Contact: Contact information such as personnel and telephone numbers where you can

inquire about the connected array. Contact information can be changed using Modify mode.

You can use up to 180 alphanumeric characters (ASCII codes) for contact information; the

following symbols cannot be used: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can use a

space in the middle of the contact information, but not before or after the contact information.

NOTE:

A contact name is required to useSNMPAgent. Besure todocumentthe contact namebecause

the settings will be cleared when the SVP is replaced.

• Location: Location of the connected array. The device location can be changed using Modify

mode. Follow these requirements: 1) Use up to 180 alphanumeric characters (ASCII codes)

when ente

ring a device location. 2) Spaces can be used with the exception of before and

after the

location name. 3)Somesymbols cannot be used,suchas ",\,;,:,,,*,?,<,>,

|, /, ^, &, and %.

NOTE:

Thedevicelocationis requiredtouse SNMP Agent. Be sure to document thedevicelocation

because the settings will be cleared when the SVP is replaced.

• Apply: Implements the settings made on this pane.

This button is active only when you select Modify mode. You must also have the permission to apply

the settings.

• Cancel: Cancels the settings made on this pane.

SNMP Agent Operations

NOTE:

To set the SNMP Agent properties from the XP Remote Web Console, you must click the Extension

SNMP check box on the SNMP IP Security pane. You must have write permission to change the SNMP

Agent properties.

Adding SNMP Manager IP Addresses

To add SNMP Manager IP addresses:

1. Change to Modify mode.

2. Click Install (

3. Clic

kthe SNMP IP Security tab (Figure 93).

13 4 S e t t i n g S N M P A g e n t P ro p e r t i e s

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 177 178

Keine Kommentare

Hp StorageWorks XP10000 Disk Array Bedienungsanleitung Seite 134