HP DL380-SL Betriebsanweisung PDF herunterladen (Seite 37)

Chapter 2: HP Clustered File System Commands 26

• lock is corrupt, will repair

This transitional state occurs after the SDMP has detected that the

SANlock has been corrupted but before it has repaired the SANlock.

• trying to lock (lock is corrupt, will repair)

The host on which mxsanlk was run is trying to acquire the SANlock. The

SANlock was corrupted but will be repaired.

• locked (lock is corrupt, will repair)

The host on which mxsanlk was run holds the lock. The SANlock was

corrupted but will be repaired.

If a membership partition cannot be accessed, use the mprepair program to

correct the problem.

When you invoke mxsanlk, it checks for the Storage Device Monitor Pulse

(SDMP) process. This process is responsible for grabbing and maintaining the

locks on the membership partitions. Depending on the status of the SDMP

process, you may see one of the following messages:

Checking for SDMP activity, please wait...

Still trying...

The SDSMP is inactive at this host.

The SDMP appears to be inactive at this host.

If the SDMP process is not responding on the host, wait a few seconds and

retry the command. If the command continues to fail, shut down the cluster

and then restart it. This step should restart the SDMP process. If you continue

to have problems, contact HP Support.

mxservice.exe – container for cluster components

Synopsis

bin\mxservice

Description

This single service controls the starting, stopping, and failure detection for all

of the operational components of HP Clustered File System. This command

should not be run directly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 140 141

Keine Kommentare

HP DL380-SL Betriebsanweisung Seite 37