HP DL380-SL Betriebsanweisung PDF herunterladen (Seite 115)

Chapter 3: mx Commands 104

The --serverSeverity argument specifies whether it is possible to

automatically fail back virtual hosts to the original server after that server has

recovered from a complete system outage. The default is autorecover. This

command can be used when the cluster is either running or offline.

delete—Delete one or more servers from a cluster

mx server delete <server> ...

This command can be used when the cluster is either running or offline.

disable—Disable one or more servers

mx server disable <server> ...

dump—Dump the server configuration to stdout

mx server dump

enable—Enable one or more previously disabled servers

mx server enable <server> ...

list—List the servers in a cluster

mx server list

This command can be used when the cluster is either running or offline.

listsoftware—List the operating system and HP software installed on the server

mx server listsoftware [<server> ...]

If the operating system uses the 64-bit architecture, x64 will be specified in the

output. Otherwise, the architecture is assumed to be 32-bit. This command

can be used when the cluster is either running or offline. If a <server> is not

specified and the cluster is online, the connected server is used. If the cluster

is offline, one or more servers must be specified.

markdown—Mark a server as down

mx server markdown <server> ...

This command can be used in situations where HP Clustered File System is

unable to fence a server that is not communicating with the cluster (for

example, because the server has crashed). The command informs HP

Clustered File System that the server has been verified to be down and does

not need to be fenced, as it cannot threaten filesystem integrity. For more

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 140 141

Keine Kommentare

HP DL380-SL Betriebsanweisung Seite 115