HP DL380-SL Betriebsanweisung PDF herunterladen (Seite 118)

Chapter 3: mx Commands 107

The maximum amount of time to wait for a probe of the device to complete.

For

NTSERVICE monitors, the default is 15 seconds. For CUSTOM service

monitors, the default is 60 seconds. For all other service monitors, the default

is five seconds.

[--frequency <seconds>]

The interval of time at which the monitor probes the service. For CUSTOM

service monitors, the default is 60 seconds. For all other service monitors, the

default is 30 seconds.

[--probetype single|multiple]

This argument applies only to CUSTOM monitors.

[--probeSeverity nofailover|autorecover|noautorecover]

The failover behavior for the service monitor. nofailover prevents failover of

the virtual host when the monitored service fails. autorecover fails over the

virtual host and, when the service is restored, fails the virtual host back to the

original network interface. noautorecover fails over the virtual host but does

not fail it back after the service is restored. autorecover is the default. These

settings work in combination with the virtual host’s failback policy.

Note that this command is case-sensitive.

[--parameters <parameters>]

The parameters are as follows:

• HTTP or HTTPS monitor. The parameter is the URL for the service.

• DNS monitor. The parameter is the address to be resolved.

• NTSERVICE monitor. The parameter specifies whether services dependent

on the monitored NT service should also be started when the NT service is

started (specify either Yes or No). If you want the services to be started,

you can also specify the number of attempts that should be made. Use a

semicolon to separate the values (for example, Yes;3)

• CUSTOM monitor. The parameter is a probe script.

[--ordering SERIAL|PARALLEL]

Whether HP Clustered File System enforces a strict ordering sequence when

it runs Start or Stop scripts. The default is serial, the strict ordering sequence.

[--recoveryScript <script>]

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 140 141

Keine Kommentare

HP DL380-SL Betriebsanweisung Seite 118