HP Designjet Universal Print Driver Bedienungsanleitung PDF herunterladen (Seite 149)

149

12. What steps should be taken to confirm SNMP v2 community name alignment exists between the printer, the HP

UPD SNMP stack, and MS SNMP stack?

The HP UPD SNMP community name defaults to ‘public’. Use any of the following methods to modify the SNMP

v2 community name:

Modify the SNMP v2 community name during installation

 Use the following install switch:

/qcomname (defined queue) or /gcomname (global)

For example: Install.exe /q /h /npf /tm /n”printer name” /nd /ni /qcomname”newame”

for Microsoft’s SNMP spooler community name

Modify the SNMP v2 community name for an existing print queue

1. From the Start menu, select Devices and Printers.

2. Right click on the printer and then select Printer Properties.

3. Click on the Ports tab and then click the Configure Ports button.

4. Select SNMP Status Enabled and then enter the SNMP v2 community name in the Community

Name: field.

5. Click OK.

Modify the SNMP v2 community name using the EWS

1. Open a web browser and then navigate to the product's EWS by using the product's IP address.

2. In the product EWS, click the Network tab.

3. Click the Network Settings link in left navigation panel.

4. Select Enable SNMPv1/v2 read-write access, and then enter the SNMP v2 community name in the

Community Name: field. Enter the same SNMP v2 community name in the Confirm Set Community

Name: field, and then click the Apply button.

NOTE: SNMP community name cannot be blank, or end in a numeric (characters 0 through 9 are reserved for

multiport jet direct box functionality).

13. How is SNMP utilized in the HP UPD?

The HP UPD’s SNMP stack provides Automatic Configuration between the HP UPD print object and the HP print

device, the Status Notification Popup after a new printer install and FILE-PRINT to HP UPD printer, and the status

message prompt for a manual duplex print job.

GET operations are used by the HP UPD (requestor) and the device (responder) over TCP/IP or DOT4

connections. SET is not utilized by the HP UPD.

The HP UPD SNMP v2 functionality requires that the SNMP community name match between the HP UPD SNMP

stack, the Microsoft SNMP stack, and that the print device SNMP settings align the Community Name in three

places: in the HP UPD printer object, the Microsoft operating system spooler, and the HP print device.

14. For point and print connected clients, is there SNMP v2 activity initiated from the client?

On the point and print client, settings on the Device Settings tab are greyed out, including UpdateNow. The client

receives automatic configuration settings and changes from the print server, not directly from the print device.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 300 301

Keine Kommentare

HP Designjet Universal Print Driver Bedienungsanleitung Seite 149