HP 441877-00F Bedienungsanleitung PDF herunterladen (Seite 36)

Adapter configurations 36

o Default for NC6170 and NC7170 adapters = No Action

o Range for NC6170 and NC7170 adapters = Disabled; Enabled; Hardware Default; No Action

• Flow Control. Determines the type of flow control that is needed. Flow control enables the

transmission of PAUSE frames. Not supported on NC71xx adapters.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

• Gigabit Master Slave Mode. Determines IEEE 802.3ab Master-Slave resolution during gigabit auto

negotiation.

o Default = Auto Detect

o Range = Auto Detect; Force Master Mode; Force Slave Mode

• Interrupt moderation. If enabled, helps to reduce number of interrupts per packet, which reduces

CPU utilization, while maintaining the same throughput. This feature is useful under heavy network

traffic conditions.

o Default = Enabled

o Range = Disabled; Enabled

• Interrupt moderation rate. Determines the amount of interrupts per second when the Interrupt

moderation parameter is enabled.

o Default = Adaptive

o Range = Adaptive; Extreme; High; Low; Medium; Minimal; Off

• IPv4 Checksum Offload. Describes whether the device enabled or disabled the calculation of IPv4

checksums.

o Default = Rx/Tx Enable

o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

• Jumbo Packet. The size, in bytes, of the largest supported Jumbo Packet (an Ethernet frame that is

greater than 1514 bytes) that the hardware can support.

o Default = Disabled

o Range = 4088 Bytes; 9014 Bytes; Disabled

• Large Send Offload Version 2 (IPv4). Describes whether the device enabled or disabled the

segmentation of large TCP packets over IPv4 for large send offload version 2 (LSOv2).

o Default = Enabled

o Range = Disabled; Enabled

• Large Send Offload Version 2 (IPv6). Describes whether the device enabled or disabled the

segmentation of large TCP packets over IPv6 for large send offload version 2 (LSOv2).

o Default = Enabled

o Range = Disabled; Enabled

• Link Speed & Duplex. Sets the connection speed to the network and mode. Full-Duplex Mode allows

the adapter to transmit and receive network data simultaneously. This property is not available for

NC310F and NC61xx adapters through the Microsoft® User Interface.

o Default = Auto Negotiation

o Range for NC340x and NC71xx adapters: Auto Negotiation; 10Mbps/Half-Duplex;

10Mbps/Full-Duplex; 100Mbps/Half-Duplex; 100Mbps/Full-Duplex; 1.0 Gbps/Full-Duplex

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 66 67

Keine Kommentare

HP 441877-00F Bedienungsanleitung Seite 36