HP 441877-00F Bedienungsanleitung PDF herunterladen (Seite 25)

Adapter configurations 25

Property Parameter

Locally Administered

Address

Enables users or administrators to set the Locally Administered Address. This address

overrides the permanent address of the adapter (that may have been flashed to the

hardware).

• Format: Hex

• Values: Valid/Not Valid (if Valid, enter the 12 hex characters of MAC address)

If an invalid MAC address is entered, an error message is logged in the event log. If

the MAC Address entered by the user is determined to be invalid, the user input

value is ignored and the MAC address used will be the physical address burned on

the card. The following addresses are invalid:

• 000000000000

• FFFFFFFFFFFF

• Multicast MAC address

Max Ethernet Frame

Size

Sets the Ethernet frame size for packet transmission and receive (does not include

MAC Header).

• Default: 1500 (corresponds to 1514 bytes on the wire + 4 bytes of CRC)

• Min: 1500

• Max: 8000

Max Jumbo Buffers Specifies the number of 8K (jumbo) buffers for receive, in addition to the standard

frame size buffers specified by "Max Receive Buffers." This is a separate pool of

buffers used by the network adapter when the incoming frame is more than the

standard frame size.

• Default: 4096

• Value: 1024/2048/4096/8192

If the MaxFrameSize is set to 1500, the Max Jumbo Buffers parameter is ignored.

Maximum Receive

Buffers

Sets the number of packet buffers on the receive (DMA memory and stack). Size of

each buffer is 1536 bytes.

• Default: 8192

• Value: 1024/2048/4096/8192/16384

QoS Packet Tagging Specifies support for 802.1p (priority) tagging or 802.1q (Vlan) tagging by the

Ethernet controller on a per-packet basis.

• Default: Enabled

• Values: Enabled/Disabled

Receive IP Checksum

Offload

Enables the receive IP checksum offload.

• Default: Enabled

• Values: Enabled/Disabled

Receive-side Scaling Enables dynamic load balancing of incoming traffic across CPUs.

Receive TCP/UDP

Checksum Offload

Enables the receive TCP and receive UDP checksum offload.

• Default: Enabled

• Values: Enabled/Disabled

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 441877-00F Bedienungsanleitung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP 441877-00F