HP 200 Unified Threat Management (UTM) Appliance Series Schnellstart Anleitung PDF herunterladen (Seite 52)

The port properties of the terminal emulation program must be the same as the default settings of the AUX

port, which are shown in the following table:

Parameter Default

Bits per second 9600 bps

Flow control

• Independent AUX port: On

• Console and AUX integrated port: Off

Parity None

Stop bits 1

Data bits 8

To log in through the AUX port:

• Complete the authentication settings on the AUX user interface. By default, password authentication

is enabled, but no password is set. To use password authentication, you must set a password for

password authentication.

• Make sure the configuration terminal has a terminal emulation program (for example,

HyperTerminal in Windows XP).

• Port settings of the terminal emulation program must be the same as the settings of the AUX

port. Table 9 lists the de

fault AUX port properties.

Table 9 Default AUX port properties

Parameter Default

Bits per second 9600 bps

Flow control Off

Parity None

Stop bits 1

Data bits 8

To log in through the AUX port from the configuration terminal (for example, a PC):

1. Plug the DB-9 female connector of the console cable to the serial port of the PC.

2. Plug the RJ-45 connector of the console cable to the AUX port of the device.

IMPORTANT:

• Identify the mark on the console port and make sure you are connecting to the correct port.

• The serial ports on PCs do not support hot swapping. If the switch has been powered on, always connec

the console cable to the PC before connecting to the switch, and when you disconnect the cable, first

disconnect from the switch.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 149 150

Keine Kommentare

HP 200 Unified Threat Management (UTM) Appliance Series Schnellstart Anleitung Seite 52