HP 200 Unified Threat Management (UTM) Appliance Series Schnellstart Anleitung PDF herunterladen (Seite 112)

106

Verifying and diagnosing transceiver modules

This section describes how to verify and diagnose transceiver modules.

Verifying transceiver modules

You can verify the genuineness of a transceiver module in the following ways:

• Display the key parameters of a transceiver module, including its transceiver type, connector type,

central wavelength of the transmit laser, transfer distance and vendor name.

• Display its electronic label. The electronic label is a profile of the transceiver module and contains

the permanent configuration including the serial number, manufacturing date, and vendor name.

The data is written to the storage component during debugging or testing.

To verify transceiver modules, execute the following commands in any view:

Task Command

Display key parameters of the

transceiver modules.

display transceiver interface [ interface-type interface-number ] [ | { begin

| exclude | include } regular-expression ]

Display transceiver modules'

electrical label information.

display transceiver manuinfo interface [ interface-type interface-number ]

[ | { begin | exclude | include } regular-expression ]

Diagnosing transceiver modules

The device provides the alarm function and digital diagnosis function for transceiver modules. When a

transceiver module fails or works inappropriately, you can examine the alarms present on the transceiver

module to identify the fault source or examine the key parameters monitored by the digital diagnosis

function, including the temperature, voltage, laser bias current, TX power, and RX power.

To diagnose transceiver modules, execute the following commands in any view:

Ste

Command

Remarks

1. Display alarms present on

transceiver modules.

display transceiver alarm interface

[ interface-type interface-number ]

[ | { begin | exclude | include }

regular-expression ]

N/A

2. Display the measured values

of the digital diagnosis

parameters for transceiver

modules.

display transceiver diagnosis

interface [ interface-type

interface-number ] [ | { begin |

exclude | include }

regular-expression ]

N/A

3. Enter system view.

system-view N/A

4. Disable alarm traps for

transceiver modules.

transceiver phony-alarm-disable

Optional.

By default, alarm traps are

enabled for transceiver modules.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 149 150

Kommentare zu diesen Handbüchern

Keine Kommentare

HP 200 Unified Threat Management (UTM) Appliance Series Schnellstart Anleitung Seite 112

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP 200 Unified Threat Management (UTM) Appliance Series