58 C
HAPTER
4: B
ASIC
S
ETTINGS OF THE
F
IREWALL
Connect/Disconnect
Pressing the Connect button in the Network Addressing Mode Section
will initiate a PPPoE session. If all fields have been entered correctly, the
Firewall will connect to the Internet. You can terminate a PPPoE session
by pressing the Disconnect button.
Specifying the
WAN/DMZ Settings
For the WAN/DMZ settings, specify:
WAN Gateway (router) Address
The WAN gateway address, also called the default gateway, is the address
of the router that attaches the LAN to the Internet.
Firewall WAN IP Address
This value is automatically set to the LAN IP Address for the Firewall
unless PPPoE is selected. For PPPoE enter the value specified by your ISP.
WAN/DMZ Subnet Mask
This value is automatically set to the LAN Subnet Mask for the Firewall
unless PPPoE is selected. For PPPoE enter the value specified by your ISP.
If PPPoE is selected, you also have to set the following:
User Name
Enter the User Name for your PPPoE account in this section. This is
information given to you by your service provider upon initial installation
of your broadband service.
Password
Enter the Password for your PPPoE account in this section. This is
information given to you by your service provider upon initial installation
of your broadband service.
Gateway (Router) Address:
This address will be provided automatically by your service provider.
For more information about PPPoE refer to “Frequently Asked Questions
about PPPoE” in Chapter 12.
DUA1611-0AAA02.book Page 58 Thursday, August 2, 2001 4:01 PM
Kommentare zu diesen Handbüchern