
Resetting the Firewall 163
Resetting the Firewall To reset the Firewall:
1 Disconnect the power from the Firewall.
2 Using a blunt pointed object, fully press in the reset button on the back
panel.
3 Whilst holding this button in, reconnect the power to the unit.
4 Continue holding the reset button in until the Alert LED starts flashing.
This should be approximately 20 seconds.
5 When the Alert LED stops flashing, the reset is complete. You can now
release the reset button.
When the reset is complete, the Firewall restarts. The Power LED stops
flashing and the Alert LED is illuminated continuously, indicating that the
unit has been reset and the firmware erased.
Reloading the
Firmware
Even when the firmware has been erased, you can use a basic Web
interface to get the Firewall up and running again. The Firewall reverts to
its default IP address of 192.168.1.254 after a complete reset, so you
must reconfigure your chosen management station to an IP address in the
same subnet to access the Web interface.
To reload the firmware:
1 Ty p e
http://192.168.1.254
into the web browser on the management
station, and press Enter. The basic Web interface loads, similar to that
showninFigure63.
Figure 63
Firmware Upload Window
DUA1611-0AAA02.book Page 163 Thursday, August 2, 2001 4:01 PM
Kommentare zu diesen Handbüchern