
40 C
HAPTER
3: Q
UICK
S
ETUP FOR THE
F
IREWALL
Manual WAN
Settings
If the Installation Wizard is unable to detect an automatic address server
on the WAN Port or if the WAN port is not connected it will display a
dialog box informing you of this and offer the choice of:
■
Connecting your Firewall (if not already connected) and restarting the
Installation Wizard.
■
Configuring your Firewall manually.
If you want to try to configure your Firewall again using the Installation
Wizard’s automatic detection then:
1 Disconnect the power cord from the Firewall.
2 Wait at least 5 seconds.
3 Reconnect the power cord.
4 Point your browser at the Firewall.
5 Follow the instructions supplied by the Installation Wizard.
If you want to configure the WAN settings of the Firewall manually then
click the Next button to continue.
The Installation Wizard will display its Connecting to the Internet screen,
shown in Figure 11 below. This allows you to specify the addressing
mode you are using on your WAN port.
Figure 11
Specifying the connection on the WAN port
The options are as follows:
DUA1611-0AAA02.book Page 40 Thursday, August 2, 2001 4:01 PM
Kommentare zu diesen Handbüchern